您还有0次抽奖机会
锤子
简介：
Two injection molded plastic samples were tested for mold release agent. The samples were hemispherical in shape. Contact angles were measured using water and methylene iodide (diiodomethane). The samples had been handled somewhat, so it was not surprising there was some variation in measurements at different locations. Because of this, five measurements of each fluid were made on each sample. The figure below shows a typical drop, in this case methylene iodide on sample #2.
打开失败或需在电脑查看，请在电脑上的资料中心栏目，点击"我的下载"。建议使用手机自带浏览器。
下载该资料的还下载了
推荐学习更多>>
-
￥50 -
￥50
-
￥50
-
￥50
- 注意：
- 1、下载文件需消耗流量，最好在wifi的环境中下载，如果使用3G、4G下载，请注意文件大小。
- 2、下载的文件一般是pdf、word文件，下载后如不能直接浏览，可到应用商店中下载相应的阅读器APP。
- 3、下载的文件如需解压缩，如果手机没有安装解压缩软件，可到应用商店中下载相应的解压缩APP。