喹那普利异丙酯模拟

论文学科】化学工程论文【论文级别】硕士论文,硕士毕业论文,硕士研究生论文【中文关键词】丙烯精馏塔论文; Aspen Plus论文; Aspen Dynamics论文; 稳态模拟论文; 动态模拟论文; 优化论文【中文题名】丙烯精馏塔过程模拟【英文题名】Process Simulation for Propylene Rectification Tower【所属分类】工程科技I,有机化工,基本有机化学工业【英文关键词】propylene rectification tower; Aspen Plus; Aspen Dynamics; stable-state simulation; dynamics simulation; optimization【中文摘要】利用Aspen Plus及Aspen Dynamics模拟软件对丙烯精馏塔的操作进行了稳态及动态模拟,通过模拟结果与实际操作结果的对比,验证了DJ型塔板具有高效率和大通量的优点,利用模拟结果与设计数据的对比关系,对液泛系数模拟值进行了76%的合理修正,开辟了以普通塔板代替DJ型塔板进行过程模拟的新方法,得出该塔的理论板数为128块,多于改造设计的估算值118块,表明改造设计对理论塔板数估算偏少导致实际塔板数不足是第一次改造不成功的主要原因。确立了合理的模拟优化步骤:确定模拟输入初值→最佳进料位置→最佳回流比→最佳产出量范围→其他优化参数。总结出了丙烯精馏塔的优化调整规律:在相同进料组成下,当进料量增加时,最佳回流比及最佳进料位置固定不变,塔釜产出量增大,产出量的可调整范围也相应扩大,塔顶冷却器负荷、塔釜再沸器负荷增大,塔釜温度基本不变,液泛系数增大;在相同进料量下,当进料组成中丙烷含量增加(来源:Aad2dBC论文网www.abclunwen.com)时,最佳进料位置板数增大,最佳回流比增大,塔釜产出量增大,产出量的可调整范围也相应扩大,塔顶冷却器负荷、塔釜再沸器负荷增大,塔釜温度降低,液泛系数增大。操作优化后,塔顶丙烯浓度在99.63%~99.65%,塔釜丙烯浓度在5.43%~7.92%。两塔位置对换,有利于大加工量下的操作。动态特性表明,无论是进料量、进料组成还是回流量扰动,均对操作产生了较大影响,主要体现在406塔釜温度、冷却器负荷、再沸器负荷、塔顶丙烯浓度、塔釜丙烯浓度、塔顶产出量、塔釜产出量的波动上,尤其是塔顶产出量和塔釜产出量不仅波动大,而且响应迅速,塔顶丙烯浓度及塔釜丙烯浓度的响应速度缓慢,波动持续时间均超过3h,动态特性要求操作人员必须采取比较平稳且循序渐进的方式进行操作调整。仪表调节规律对动态特性具有重要的影响。(来源:ABabC论文0808网www.abclunwen.com)【英文摘要】 The process of propylene rectification tower was simulated in stable-state and dynamic simulation with Aspen Plus and Aspen Dynamics.The high efficiency and large throughput of DJ type plates were verified by comparing the simulateion results with practical operating results.The simulation value of flooding modulus was modified reasonably by 76% using the contrast results between simulation results and design data.A new way of process simulation with common plates instead of DJ type was created accordingly.It was found that the number of theoretical plates was 128,more than designed number of 118 for reconstruction,which indicated that the main reason failed the reconstruction for the first time was the lack of plates due to estimated less of designed theoretical number of plates.Reasonable optimum simulation process were:confirmation of simulation input initial value―best feed inlet―best reflux ratio― best yield range― other optimized parameters.The optimized adjusting rules for propylene rectification tower were summarized as following:with the same composition but increased amount of feed, the best reflux ratio and feed inlet kept unchanged, and the yield of column went up, the adjusting range of yield expanded respectively,the load of overhead condenser and column reboiler raised,the temperature of column stabilized and the flooding modulus added too;with the same amount of feed but increased content of propane,the number of plates in the best feed inlet,the best reflux ratio and the yield of column increased respectively,and the adjusting range of yield expanded,load of overhead condenser and column reboiler raised,column temperature down and flooding modulus up.Followed with optimized process,the concentration of propylene overhead kept at 99.63% to 99.65%,and the concentration in column pot lied from 5.43% to 7.92%.Exchanging the two towers position was beneficial to process under large amount.Dynamics properties showed that the amount or composition of feed,or quantity of reflux disturbance all had relatively great impact on the process,which mainly reflected on the fluctuation of 406 tower pot temperature,condenser and reboiler load,concentration of propylene over and in the column,the yield over and in the column which not only fluctuated greatly,but responded rapidly.The concentration of propylene over and in the column responded slowly and the fluctuating period exceeded 3 hours.These dynamic properties required steady and gradual operation and adjustment.The adjusting rules for instruments impacted the dynamics properties greatly.中文摘要3-4ABSTRACT4前言7-8第一章 化工过程模拟技术的发展与应用8-15[

如何通过氢谱 和碳谱化学位移值，模拟分子式或者分子结构。就是想知道现在有相关的核磁软件具有这个功能吗。比如gNMR或者Nuts软件。现在有的可以是画出结构式，模拟氢谱和碳谱化学位移。我想了解有反过来知道化学位移，模拟出分子结构式的吗？望熟悉的朋友说说啊，谢谢呢，急

作为仪器一线操作者的我们，每天的工作就是和仪器操作打交道。对于仪器操作，我们是内行，但却不知道这台仪器是怎么买回来的，也很少去研究仪器采购的流程。现在，机会来了！我们就来模拟一个采购液相色谱仪的流程，由你来决定这次采购的一切，直到把仪器送到操作者手里。[color=#DC143C][B]我来出道具[/B]：资金30万-60万，60万减去最后仪器价格差的1%作为你的奖金，也就是说价位越低你的奖金就越高；[B]仪器必须要求：[/B]2个以上的泵（为了走梯度洗脱）、自动进样器、C18色谱柱2根等等；[B]购买方要求：[/B]在现有资金和基本要求的情况下，使仪器配置、性能等越高越好。[/color]好了，情况就是这样啦！[em09510][color=#00008B]游戏规则如下：1.价格可以估计，如果你是销售商可以纠正模拟的价格，并在“采购员”提出自己想法后给与回答2.仪器品牌在价格范围内选择3.根据采购进度，会有不同的提示帖或结论帖，大家可以写出自己的想法[/color]奖励措施：描述部分过程、全部过程的奖励分数为2-10分、10-30分！此过程色谱采购交流版面全体版主和专家将时刻跟进和大家一起交流、讨论！[em09511]一起来吧！[em09505]