色谱中首先流出

QuickPick 分流出口和进样口预防性维护工具包5188-64967890/6890/6850 分流/不分流进样口备件（上图）项目说明单位部件号1 Merlin 微量密封垫套件，低压5181-8816Merlin 微量密封垫启动套件，通用5182-3442Merlin 微量密封垫高压螺帽5182-34452 Merlin 微量密封垫低压更换隔垫5181-8815Merlin 微量密封垫通用可更换隔垫3-100 psi 5182-34443 隔垫螺帽，吹扫进样口18740-60835顶空隔垫固定螺帽18740-608304 不粘连流失与温度优化(BTO) 隔垫，11 mm 50/包5183-4757100/包5183-4757-100不粘连长寿命隔垫，11 mm 50/包5183-4761100/包5183-4761-1005 7890 顶部插件组件，标准G3452-607307890 顶部插件，AC gang 接头焊件G3430-600117890 顶部插件组件，阀G3480-675857890 插件焊件，经UltiMetal Plus 工艺处理G3452-605866890 顶部插件组件，标准G1544-605856 不分流衬管用的石墨O 形圈10/包5180-4173分流衬管用的石墨O 形圈10/包5180-4168验证的不粘连氟碳O 形圈10/包5188-53657 Cap 进样口外层焊件组件G3452-805707890 Cap 进样口外层焊件组件，经UltiMetal Plus 工艺处理G3452-605708 QuickPick 分流进样口预防性维护工具包5188-6493QuickPick 不分流出口和进样口预防性维护工具包5188-6497FID 收集极清洁刷8710-1346QuickPick 分流出口和进样口预防性维护工具包5188-6496色谱柱安装预装配工具，金属密封垫圈G3440-80218色谱柱安装预装配工具，石墨密封垫圈G3440-80217

产品特点：分流出口捕集管Split Vent Trap Replacement Cartridges, 3/pkSKU: 21023 Categories: Gas Purifiers & Traps, Tools for Chromatography Tag: Split Vent TrapsDescription● 和P/N 21026一起使用Cartridge Replacement:Replacement cartridges are supplied with plastic end capsto prevent air contaminants from depleting the charcoal. The split vent trap does not need to be removed from the GC to replace the cartridge. Simply unscrew the outer plastic tub from the large fitting on the inlet end, then remove the cartridge. Leave the rubber O-rings in place inside each large fitting. Remove the plastic end caps off the new cartridge, slide it into the outer plastic tube, then screw this back onto the first large fitting. Tighten only finger-tight, which will be about 1/4 to 1/2 turn past the first point of resistance. Do not over tighten.Additional information重量0.37 lbs尺寸0.37 x 0.37 x 0.37 in

产品特点：分流出口捕集管Split Vent Trap with 3 Cartridges, eachSKU: 21026 Categories: Gas Purifiers & Traps, Tools for Chromatography Tag: Split Vent Traps● 高容量● 易于更换 The split vent trap attaches to the GC?s split vent to absorb organics released during sample injection. The trap contains 1200 mg of activated charcoal from coconut shells, which is a very effective scrubber of organics. It will absorb hydrocarbons other than methane at room temperature. Since there is no good indicator of when the absorption capacity has been reached, monthly or bi-monthly replacement of the charcoal tubes is recommended, depending on the frequency of GC use. The split vent trap consists of glass absorbent tubes, 1/8″ end fittings and a clear plastic protective sleeve. The trap is approximately 6 3/8″ long including fittings.安装:The split vent trap is supplied assembled, with 1/8″ fittings at each end. Remove the plugs at both ends by unscrewing the nuts. Either end of the trap can be directly attached to the outlet tubing from your GC?s split vent, if it is 1/8″ in diameter. For other size outlet tubing, use an appropriate reducing union (not included), or change the outlet tubing to 1/8″ diameter. Use a wrench to tighten the fitting onto the split vent outlet tubing 3/4 turn past finger-tight. The exit end of the trap requires no tubing. The split vent trap is generally installed in a vertical position.更换捕集管:Replacement cartridges are supplied with plastic end caps to prevent air contaminants from depleting the charcoal. The split vent trap does not need to be removed from the GC to replace the cartridge. Simply unscrew the outer plastic tub from the large fitting on the inlet end, then remove the cartridge. Leave the rubber O-rings in place inside each large fitting. Remove the plastic end caps off the new cartridge, slide it into the outer plastic tube, then screw this back onto the first large fitting. Tighten only finger-tight, which will be about 1/4 to 1/2 turn past the first point of resistance. Do not over tighten. Additional informationWeight0.37 lbsDimensions0.37 x 0.37 x 0.37 in